Resultat 1 till 3 av 3

Ämne: Någon som vet vad detta är?

  1. #1
    jupiterdream
    jupiterdream är inte uppkopplad

    Senior

    Någon som vet vad detta är?

    Gick igenom lådan med reservdelar till gamla Arp. Men vet inte vad det är och till vilka maskiner de hör. Någon som kan hjälpa mig identifiera?
    Klicka på bilden för en större version. 

Namn:	DSC03761.jpg 
Visningar:	48 
Storlek:	87,2 KB 
Id:	32805Klicka på bilden för en större version. 

Namn:	DSC03762.jpg 
Visningar:	44 
Storlek:	89,5 KB 
Id:	32806Klicka på bilden för en större version. 

Namn:	DSC03763.jpg 
Visningar:	52 
Storlek:	95,3 KB 
Id:	32807Klicka på bilden för en större version. 

Namn:	DSC03768.jpg 
Visningar:	52 
Storlek:	96,2 KB 
Id:	32808Klicka på bilden för en större version. 

Namn:	DSC03772.jpg 
Visningar:	43 
Storlek:	96,0 KB 
Id:	32809

  2. #2
    rwq
    rwq är inte uppkopplad
    rwqs avatar
    Veteran
    Detta är snyggt!

  3. #3
    jpl
    jpl är inte uppkopplad
    jpls avatar
    Veteran
    del av en arp avatar?

    "3.5.6 E'MODULE
    The E' Module accepts the guitar signal from the Audio Multiplex Circuit (MUX, pin 17) and extracts from it a pulse wave (CLK and CLK). This clock output (at the frequency of the guitar string) is sent to the D board for processing. The three bit string code from the String Select Circuit is supplied to pin 13, 14 and 15 so that the circuit can 'set up' for the open string frequency of the guitar signal it is to receive. The clock output (CLK, pin 23) is also sent to the Limit Detector Circuit to generate Transfer (XFER) and Clear (CLR) signals. The level signal from the E' Module goes high to confirm that an extracted signal is appearing on the clock output.
    The CV input (pin 6) comes from the output of the D' Module and is used to adjust the E' circuit to the pitch which is being extracted. After an initial pluck, the TRAIN signal (pins 10, 12) causes the E' Module to ignore temporarily the CV input until a new pitch has been extracted and processed through the D board.
    The Q GATE inputs (pins 20 and 19) instruct the E' Module to begin extraction."

Liknande ämnen

  1. Svar: 1
    Senaste inlägg: 2010-03-14, 20:10
  2. Hur gör man detta?
    Av plastocid i forum Effekter
    Svar: 19
    Senaste inlägg: 2006-03-13, 23:58

Behörigheter för att posta

  • Du får inte posta nya ämnen
  • Du får inte posta svar
  • Du får inte posta bifogade filer
  • Du får inte redigera dina inlägg
  •